Hotline:
0579-84736588
Hotline:
0579-84736588
23
2022/11
Imitation die-casting pot, the process is similar to the stretching pot. The aluminum sheet is also used. The aluminum sheet of the imitation die-casting pot is thicker and pressed by the forging press. The cost and the threshold are improved. It can …
03
2022/03
1. Apply with edible oilWhen using for the first time, there is a layer of protective film on the non stick pan. Before using, it must be washed with clean water and wiped dry, and then coated with a thin layer of edible oil to maintain the coating on…
18
2021/07
Nowadays, there are more and more types of pots on the market. They are bought and used indiscriminately without maintenance. They will break after a long time. The following editor will introduce several common maintenance methods for pots.The newly-…
10
2021/03
First wash it clean with detergent, then fill it with water, sprinkle with a little salt, and soak it for 24 hours before use.Before using the non-stick pan you bought, you should wash and dry the pan first, and apply a thin layer of cooking oil on th…
13
2020/11
1. The common ones are 18/10 or 18/8 stainless steel. The bottom of the pot is a composite bottom with pure aluminum to achieve uniform heat conduction. (The thermal conductivity of stainless steel is 15, and aluminum is 230). Rugged and durable, with…
29
2020/05
Any production process requirements are selected according to the product quality requirements, and the die casting pot blank has high quality requirements. It is mainly reflected in the surface roughness, high temperature baking, no bubbles, no pinho…
21
2020/05
(1) After the metal enters the cavity, it should be designed for the first impact position, so that it can be exhausted and the forward flow of smelting liquid should be stored. The side gate is selected for the die-casting pot, so the overflow groove…
22
2019/06
To ensure the quality of the product, the quality control point of the die-casting pot must be established at the primary part of the entire production process. Below, the non-stick pan export manufacturers, die-casting pot manufacturers and non-stick…
19
2018/08
1. The manufacturing process of the pot is mainly divided into three types.The first one is a stretching pot, which is the simplest and lowest cost. It is used to make non-stick pans. It is usually made of aluminum and stretched with a stretching mach…
22
2018/05
Die-casting pot, process generally similar to drawing pot, also use aluminium, just copy aluminium die-casting pot thicker, use forging press down, the cost and the threshold, general middle and small factory can produce. The thickness of the pot body…
21
2017/01
Cooking needs a variety of instruments. It is the hardware industry in both traditional and emerging products and services. The so-called traditional mainly refers to the 1980s as the base material is aluminum and iron products produced; the so-called…
02
2016/10
Pot, Chinese people are the most indispensable daily necessities, lift the pot, people want most is the wok, in fact, with the development of society, pots and pans also make improvements change, especially when the housewives more and more attention …
Add:Lengshui Industrial Zone,Panan,Zhejiang China
Tel:86-579-84736588
Mob:13566919856
Fax:86-579-84736168
E-mail:sales@hhcookware.com